Anigrand C-17 Globemaster III Review

Story time from my experience with a C-17: I was taking off out of my home airport, making a left climbing turn towards the Oregon coast when my iPad showed traffic a few thousand feet above me. I looked out the window scanning for the traffic. It wasn’t hard to miss: a giant C-17 slowly flying north towards Seattle. It was probably 5 miles out and a few thousand feet above, but from my vantage point the airplane looked massive. It was truly one of the most memorable experiences I’ve had as a pilot. Since then I’ve seen that plane a few more times at air shows and it's been on my modeling wish list since.

While at a model swap meet, I saw this kit from Anigrand. C-17: check. 1/144 scale: check. Resin: what? I’m familiar with resin parts, but not entire resin kits. I’ve read about them before, but didn’t really know entire resin kits still existed. I was intrigued knowing that resin parts are renowned for their detail and quality, so I picked up this kit hoping to learn more about this material and make a high quality replica of the C-17.

Anigrand makes lots of different resin kits, and they are quite expensive. I was able to pick this one up for $36. This kit really is my entry point into the small batch, limited run enthusiast market. Labeled parts? Who needs it? Instructions? I’m a pilot; I can figure it out. Cleaned parts? Where’s the fun in that? This kit really was a whole new world for me. It was time to get started.

My first step was sorting parts into like pieces and making sense of what I had. Interior was molded into the two halves of the fuselage, so there was nothing to build there. I started by sanding the halves and gluing them together. After all of my prep work, there were still considerable gaps all over the model. After several passes of filler, sanding, and primer, I was able to get it to mostly look fine. Next came the wings and tail. In no time, we had an airplane. I painted it Vallejo Model Air dark sea gray which turned out to be a perfect match for the real color.

Next I built the engines. Lots of cleanup was required to remove pour stubs and excess flash. These parts were quite messy and had lots of imperfections. One thing I learned very quickly is that resin is nasty and a respirator is required. I did my very best to get everything cleaned up as good as possible, but there remained some imperfections that were out of my control. Once again fit wasn’t great on the engines and the two halves didn’t come together very well. Pieces did have alignment pins, but they either broke off when trying to line it up, or the hole on the other half was too small. A pin vise and drill bit came in handy many times.

Next was the landing gear. This is a time when I really wished I had instructions. It took me several hours to make sense of these parts and what to do with them. Eventually I got them together only to realize that there is a left and a right. Despite very minor differences, the parts do need to go on their correct halves. If you build this kit, you need to pay very close attention to alignment and how things fit. If they don’t look right, it could be that they need to go on the other side of the plane. That includes the flap hinge fairings, engines, landing gear, belly fins, and main gear bays.

The kit supplies a small sheet of decals. They went on pretty well without any issues. In the end, I’m very glad to be done with this kit. A lot of time and effort went into completing this airplane. Despite the price, it’s not very detailed. I expected more from a resin kit, and this was no better than a normal styrene model. I would not recommend this kit. It’s very expensive and it’s not worth the effort or time. I’ve seen cheaper kits with more surface detail that you would be better off getting.

C-17 Globemaster III scale modelC-17 Globemaster III scale modelC-17 Globemaster III scale modelC-17 Globemaster III scale modelC-17 Globemaster III scale model

More reviews