Meng Ford F-350 Review
The Meng F-350 marks my introduction to vehicle models. I’ve never attempted modeling a car before, largely due to the lack of vehicle models that interested me. I picked this kit up at an IPMS swap meet for relatively cheap (cheaper than the going rate I listed in this article). It was just sitting there on a table, calling me in. I was enticed by the fact that this vehicle was younger than me. Despite the relatively small scale for a vehicle, I picked it up, excited to get started on a car model that actually interested me.
Wanting to make it my own, I decided to disregard all of the colors stated in the instructions. All of the colors in the instructions were given in Vallejo Model Air codes, which was useful since that’s primarily what I use. I wanted to paint it pearl white. I picked up Vallejo Metal Medium, thinking it was a nice color and had the opportunity to turn basic colors into metallic shades. If you’ve read reviews on that paint, you’d know where this is heading. First, it does not at all turn normal paint into metallic paint. All it does is make them a lighter shade. Secondly, it’s way too thick to airbrush. Thinned heavily I was able to get it to spray, but it never covered well and surprisingly lacked any amount of metallic flakes.
I scrapped the paint job and went for a nice gloss red. I picked up my first ever Tamiya paint and decided to give that a go. The hobby store was all out of thinner, so I used 91% rubbing alcohol. Not ideal, but worked well enough for me to see if I like this brand of paint. First, I primed it with Mr. Surfacer 1000, then the red paint. It went down decently and looked great over the gray.
For the interior, I painted that sand beige with a black wash in areas like the speaker grills and cup holder. The dash was a mix of black and beige. The kit includes only 4 distinct decals. One of which was the instrument panel. The decals were pretty good. It took a good, long soaking in water and a few minutes on a paper towel before I was able to convince them to slide off the paper. However, they responded well to setting solution.
This is a curbside model, unlike its 1/24 counterpart. Despite that, it has a fairly detailed exhaust and suspension system. All of it went together well and fit without any issues. The only reason this isn’t a 5 star kit is the fit issues with the tub. When it came time to mating the tub to the shell, it was a very tight and difficult fit. There was a wider plastic piece at the back of the tub that seemed like it should be there, but would not fit with it present. I ended up trimming the edges and it fit fairly well. It took some more adjustment to get the wheel wells to line up evenly on both sides.
The kit comes with a few options to choose from. There are two wheel options: steel and aluminum (although the spare must be steel). You also get the choice of running board or tube aluminum steps. Finally, you get the option of a bed extender frame or just the tailgate.
Overall, I really like this kit. It was a fairly simple project with not a lot of different colors involved. Instructions were clear, most everything fit good, and it was really well detailed. While it was fun doing a car model, I still like airplanes. You can expect to see some occasional vehicles modeled here in the future, but airplanes still have a special place on my bench.








More reviews
- Academy T-34B Mentor Review
- Airfix Boeing Chinook HC.1 Review
- Eduard L-39 Albatros Review
- Italeri V-22 Osprey Review
- Tamiya A-1H Skyraider Review
- Minicraft Cessna Citation I Review
- Revell Porsche 911 Carrera Review
- Minicraft Beechcraft Bonanza V35 Review
- Revell F-15E Strike Eagle Review
- Building an Abandoned Ghostbusters ECTO-1