Revell UH-34D Review

The UH-34D Seahorse marks my introduction to helicopter models. I fly airplanes in real life, but have never been in a helicopter. My interest in this specific model comes from seeing the president arrive in Marine One. While this isn’t the exact model they fly in, it reminded me of my visit to Washington DC. I picked this kit up for $10 at a model swap meet, so it seemed like a good start to helicopter modeling.

Build started with the interior. There are two separate pieces that join together later. The cockpit is very basic. The instrument panel is completely flat and blank, however the kit comes with a decal. The seats are decent, but other than that there is no molded detail. The same goes for the lower cabin. The bench seats have some nice detail, as well as the walls, but the floor is blank. I used a scribe and rivet tool to add some details. To further enhance everything, I first painted the floor a lacquer silver. Then I covered it with dark ghost gray acrylic. Since the acrylic is softer than the lacquer, I used sandpaper to scratch and chip the floor. The gray was removed in high traffic areas to reveal the silver underneath. The end result is very realistic and I’m really happy with the look.

After that, the two interior pieces get glued into one half of the fuselage. Getting the two halves to fit together was fairly difficult. Alignment wasn’t the best, and lots of filler was needed. This is probably the most time I’ve spent filling, sanding, priming, and repeating. In the end I did get a fairly good result with a near invisible seam. The more difficult part was getting a realistic seam on the engine door. The two halves didn’t fit together perfectly, and alignment suffered. The difficult part was getting them to fit together while retaining the seam of where they open at. It’s not perfect, but the decals will cover much of it later.

Assembly of the rotor system was complex and finicky. Long, flexible blades coupled with thin, fragile rotor components made assembly difficult. In order to allow the blades to turn, a lot of the pieces were press fit. Tolerances were tight and the pieces were thin, so some things got broken along the way. Same goes for the tail rotor.

Since the pieces were so fragile, I weathered and added decals before installing the landing gear and rotors. I weathered using yellow oils to highlight panels and give it a faded look. Then I used black pastels to add soot and exhaust residue.

Decals for this kit were a nightmare. While the sheet was relatively small, there were over 60 unique decals squeezed into it. So many that the helicopter almost looks too busy. My specific kit was manufactured in 2012, so your experience may vary based on the age and version of your kit. In my experience, the decals were very thick and stiff. It could be due to the age, but adhesion was poor. Especially with the larger decals, they did not stick at all. Setting solution didn’t help, and softener didn’t make any difference in having them conform to the surface. Silvering was a major issue, especially on decals that bridged panel lines or went over the raised rivet detail. None of the decals responded to Micro Sol, so a stronger solution would be needed. For me, decals always make or break the model, and I feel frustrated when nice looking decals go on bad and ruin the finish of an otherwise good kit that I put a lot of time into.

Overall I wouldn’t necessarily recommend this kit. It lacks detail for being a 1/48 scale model. Fit wasn’t great and needed lots of work. And the decals were thick and difficult to work with. There are plenty of other UH-34 kits in existence, so I would recommend looking at a different brand before going for this one. Rotors were difficult to work with, so I will think twice before getting another helicopter model. With that being said, I do have one more in my stash that I am still looking forward to getting started on.

Sikorsky UH-34 scale modelSikorsky UH-34 scale modelSikorsky UH-34 scale modelSikorsky UH-34 scale modelSikorsky UH-34 scale modelSikorsky UH-34 scale model

More reviews